|
|
发表于 2012-1-30 21:22:41
|
显示全部楼层
来自： 中国广东珠海
本帖最后由 lixinqiou 于 2012-1-30 22:31 编辑 7 r( m0 C+ K& L+ ^0 a
0 s$ o# H" O+ s, m
1# mi15988 同解！E文不好，麻烦哪位楼主翻译下：
: [1 D5 d; ~0 R3 ~! C' e4) Install a USB-Win64 Emulator
6 u P& d- G: |7 J- F4 QYou need a local Administrator rights to install this emulator for Win64!) j; \0 G, ]$ g" N
On Windows Vista64 and Windows7 64-bit you need to boot Windows in mode F8 > Desable Unsigned Drivers Enforcment !!!
0 u: b! {: k4 w9 D+ S+ I# w4.1. Reboot computer (for Windows Vista64 and Windows7 64-bit you need to boot Windows in mode F8 > Desable Unsigned Drivers Enforcment !!!)
1 U8 F& m2 q# [7 [; A8 o2 P4.2. Install usb-emulator drivers4 H9 V7 D7 c4 @; y6 z2 w. N, `
Start -> Control Panel -> Add Hardware (Yes, I have already connected the hardware) -> Add a new hardware device -> Install the hardware that I manually select from a list -> Show all Devices -> Have disk -> Browse -> (browse to folder "USB-Emul_Win64") -> OK -> Confirm to install not certificated drivers if Windows ask for..
) _! u' O7 T2 A: W x" {If setup is succesfull you have to see new system device:9 O+ y$ D# w" A8 z
Device Manager -> System devices -> Virtual Usb Bus Enumerator
8 P' Q9 I n7 c( E$ S1 s" ^) n a. y
& i2 r3 {6 M8 ~" ^3 L3 l1 o5) Install MC X6 v15.0.4.3 64bit as HASP or NetHASP SIM type. 3 y# }' j, o* L+ D0 s
6) Copy Mastercam.exe from crack to <Mastercam X6 progdir> and replace original one
8 m& w' }0 s: o& Y, A8 W7) Enjoy
0 }/ H9 ~+ T% G3 c0 |2 I' ?2 h多谢！现在知道了，不好意思！ |
|
楼主