|
|
马上注册，结识高手，享用更多资源，轻松玩转三维网社区。
您需要 登录 才可以下载或查看，没有帐号？注册
x
TOOL CHANGE: FIRST:
/ \- @. r; s$ E: Y! O' w9 D$ z SET_ON SPIN_SPEED SPIN_DIR ; ; o/ h% d! y: y* ~5 H
*-----save first tool number 5 j' w# f0 T8 _9 Z5 l
FirstTool = CURR_TOOL ;
3 Q& g+ w. {5 }5 {; ^, {' C LastTool = CURR_TOOL ; 7 B$ y4 @% g8 ]: i& y4 ~
y! t, z9 Q/ N/ K*-----tool cutter compensation register number
5 @2 a" y; x! | CutterComp = CURR_TOOL + DiaComp ; 5 x, @- c# u- k. M) p- U. q
4 {1 W9 n9 `5 j( Z9 n8 i*-----assuming 1st tool is in the spindle, there is no need
+ Q, E0 G! u' J* for tool change)
4 [0 m* N* q2 x. y* OUTPUT $ " T" CURR_TOOL ; 7 s9 N" D7 _; q. i$ Z
*-----more then one tool in this run of the Post Processor ' q( r$ N+ d# r
IF_SET (NEXT_TOOL _NE_ CURR_TOOL)
# S1 D, Y. F7 L* q, R OUTPUT $ " T" NEXT_TOOL ; . @6 h7 g' [* |% `, a
END_IF ; - ^9 w7 Y2 D( C
*-----standard tool change commands. (assuming 1st tool is in
3 a2 P7 F) u/ s+ J: Y$ ~4 U! \0 Z OUTPUT $ " G90 G80 G00 G17 G40 G54" ;
# D; f8 N1 t2 Y3 x3 B! G$ M5 y6 ^0 y OUTPUT $ " Z" Zhome " S" SPIN_SPEED " " SPIN_DIR ; ( F$ |0 h( s3 r1 _$ I
OUTPUT $ "( 刀具名称---" CURR_NAME "×" CLEAR_LENG ")"; ( I) }7 S2 x8 \6 N
OUTPUT $ "( 曲面偏移=" PART_OFST "曲面公差=" PART_TOL" 轮廓偏移=" CONT_OFST " )";1 G6 w, y6 R/ u3 V# W( i& f
OUTPUT $ "( 程式名称=" TP_NAME "本程式由" USER_NAME "编制 )";
5 m. e1 N u! D; a: J) Z+ c+ f H. G4 }, n
& \ p# e/ i; t1 @" t: j 说明：1、*注释或代表不执行此内容；
" e* q4 z+ H! {* v1 ]$ g9 o& D, o$ D 2、 引号里内容则按实输出；* w% P1 o3 m2 s' Y
3、修改保存完毕执行主菜单--NC--DFEXF--输入后处理名--回车即可。 |
|
发表于 2007-12-14 17:18:02