|
|
马上注册，结识高手，享用更多资源，轻松玩转三维网社区。
您需要 登录 才可以下载或查看，没有帐号？注册
x
TOOL CHANGE: FIRST: . z1 f8 `7 j) K" H/ y m7 P
SET_ON SPIN_SPEED SPIN_DIR ; $ ~! N1 x' b& S E9 t8 ^
*-----save first tool number - r) c! P' I# B3 n! F, M/ n: f/ Q
FirstTool = CURR_TOOL ;
+ k/ r) A5 Q1 I, b. g6 Q# g# |) R LastTool = CURR_TOOL ;
7 N5 O- [' l. z5 g7 j& n
- y, G1 z6 g3 f i5 P) N*-----tool cutter compensation register number 7 y! L! W' C( c
CutterComp = CURR_TOOL + DiaComp ; 7 j# g& m- i8 B& H. n
( t( T# Y# b L7 D @6 T5 _4 p*-----assuming 1st tool is in the spindle, there is no need
$ _! J, O9 j$ L( F3 m* for tool change)
: p) D/ D% j9 F+ W9 x. q* OUTPUT $ " T" CURR_TOOL ; 9 [; A% \9 e* h* c
*-----more then one tool in this run of the Post Processor % n6 E) }+ j! W2 w3 q* Q' ]
IF_SET (NEXT_TOOL _NE_ CURR_TOOL)
+ L! R1 Z7 u! i' A; v0 R, U/ a OUTPUT $ " T" NEXT_TOOL ;
$ \, h* ?: { P& J, a5 ? END_IF ;
; R1 A# P- y7 V4 e. W*-----standard tool change commands. (assuming 1st tool is in
) r. S1 ^$ l( ]! Y( K OUTPUT $ " G90 G80 G00 G17 G40 G54" ;
& |4 I2 N: P+ @7 Z2 i( R OUTPUT $ " Z" Zhome " S" SPIN_SPEED " " SPIN_DIR ; 3 U' G2 s- h* y. g5 y) y
OUTPUT $ "( 刀具名称---" CURR_NAME "×" CLEAR_LENG ")"; 9 L, T: {3 h8 s% q) T( P
OUTPUT $ "( 曲面偏移=" PART_OFST "曲面公差=" PART_TOL" 轮廓偏移=" CONT_OFST " )";- V6 a* ]. }. ^3 |/ C9 K
OUTPUT $ "( 程式名称=" TP_NAME "本程式由" USER_NAME "编制 )";+ @& k1 c+ Z! a3 |6 h. i
6 c* O* [& A# F& }% H
" d- K* ]6 L% _* j! O1 m+ r! O 说明：1、*注释或代表不执行此内容；- w( J( r, q }3 H
2、 引号里内容则按实输出；8 x" u/ y/ y* ^% @3 y% S& f1 l! W
3、修改保存完毕执行主菜单--NC--DFEXF--输入后处理名--回车即可。 |
|
发表于 2007-12-14 17:19:03