|
|
楼主 |
发表于 2022-1-6 18:57:10
|
显示全部楼层
来自： 中国
# General Output Settings
( v) G3 d$ w* r9 j/ r% i2 s6 y& E# --------------------------------------------------------------------------# B& L$ E5 Z+ l: T
maxfeedpm : 500 #SET_BY_MD Limit for feed in inch/min/ W3 d* \" T* N+ S: l- G; b% A1 E
ltol_m : 0.05 #Length tolerance for arccheck, metric
2 @, J0 D' a$ y; Dvtol_m : 0.0025#System tolerance, metric
) ]" Z; ^' ]7 Q* Y9 R# Imaxfeedpm_m : 10000 #SET_BY_MD Limit for feed in mm/min% X1 {$ q0 K0 C. A# c6 `& n9 n
force_wcs : yes$ #Force WCS output at every toolchange?
. q3 B" {. N7 x% b* Z9 Mstagetool : 1 #SET_BY_CD 0 = Do not pre-stage tools, 1 = Stage tools3 Q) {' ?; T+ z# Y0 K O0 j
stagetltype : 1 #0 = Do not stage 1st tool; Q; P/ E" j+ t! f
#1 = Stage 1st tool at last tool change
1 `7 `4 r! l9 n- v #2 = Stage 1st tool at end of file (peof)
4 N2 D4 |: \4 f' I9 J# Puse_gear : 0 #Output gear selection code, 0=no, 1=yes
Q/ X6 G# t9 B! g. x$ i1 s/ Imin_speed : 50 #SET_BY_MD Minimum spindle speed
4 O: a$ d; [+ @progname$ : 1 #Use uppercase for program name (sprogname)
$ \0 p- @$ q7 Y2 ~prog_stop : 1 #Program stop at toolchange: 0=None, 1=M01, 2 = M000 Z! y4 Y0 {( J: z# j
tool_info : 3 #Output tooltable information?3 n1 p- F2 ^" p- P, l+ X: i. m
#0 = Off - Do not output any tool comments or tooltable |
|
发表于 2022-1-6 18:53:58
