motion分析无法找到初始位置！！！！

goodluckjl586

简单模型在设置运动后仿真出现错误，无法找到初始位置：
The Initial Conditions displacement solution failed.  ADAMS/Solver could not determine the initial assembled position configuration of the model.
" G" ^1 p+ }9 T4 D* r* ^) `1)Try increasing the number of iterations for convergence.  Current value: 25.
2)If redundant constraints are present try to eliminate as many as possible.
& ^5 Q# {6 d6 h3 g3)Make sure prescribed motions are consistent with other aspects of the current model position.
4)Check to see if joints are inconsistent (contradictory); eliminate them if so.
5)Check to see if parts are not too distant from an assembled configuration.
3 e8 _. T! Z0 m' q! {4 j5 l+ T1 G
% |3 \2 w. l$ i; D5 \4 N0 A/ k曲柄处设置圆周运动，底座固定，无论z，x轴在底座上怎么设置，仿真都出现问题。。。但将曲柄旋转中心左移到底座左侧以外就可以仿真 ;) ;) 新手不懂，请教。。。

goodluckjl586

做分析的没有遇到这种情况吗？

kiu2001cn

建议你检查你的模型配合是否出错，从新装配，装配时先把左侧驱动结构装上，再装配从动结构