|
|
马上注册，结识高手，享用更多资源，轻松玩转三维网社区。
您需要 登录 才可以下载或查看，没有帐号？注册
x
TOOL CHANGE: FIRST:
* K3 z5 B: b8 `; |: U8 c; z SET_ON SPIN_SPEED SPIN_DIR ; 6 M2 @, _- p6 v/ |8 I
*-----save first tool number
( r# r3 I7 g8 A5 R* u FirstTool = CURR_TOOL ;
9 |8 r" d1 _9 z. e/ Q* i$ u# s/ s% i LastTool = CURR_TOOL ;
; e7 v# ]- O7 f1 x2 L
/ h `0 O3 Z" B: P/ j: e6 z* L* U*-----tool cutter compensation register number + Y! U* Z5 ` _' \
CutterComp = CURR_TOOL + DiaComp ;
! W1 M. ]" i- p5 m) U% P; g
) @) `. t s- ]3 \4 C/ O5 r*-----assuming 1st tool is in the spindle, there is no need
; E; Q* d- N4 j/ E- y* for tool change)
( u. k# {$ e/ ?8 [* OUTPUT $ " T" CURR_TOOL ;
* j% C5 b4 j6 ?* R3 t4 j6 ]*-----more then one tool in this run of the Post Processor
4 C5 K+ b! Y) @8 H IF_SET (NEXT_TOOL _NE_ CURR_TOOL)
j' s6 e; f5 n$ J8 _/ \1 ~# z OUTPUT $ " T" NEXT_TOOL ; ' U, l/ }# A% ^2 A1 Q9 Q$ ~& b
END_IF ;
" f' V$ {% Y2 Z8 x6 L*-----standard tool change commands. (assuming 1st tool is in 5 N h: t7 `- R" `6 s: m, I9 [! k
OUTPUT $ " G90 G80 G00 G17 G40 G54" ;
P% C6 q7 b( t q9 ^# i$ j% A OUTPUT $ " Z" Zhome " S" SPIN_SPEED " " SPIN_DIR ;
: N9 l- l- r7 V0 `- k OUTPUT $ "( 刀具名称---" CURR_NAME "×" CLEAR_LENG ")";
; Y6 }! e% B( c# W# b& ]1 l7 a: D# a OUTPUT $ "( 曲面偏移=" PART_OFST "曲面公差=" PART_TOL" 轮廓偏移=" CONT_OFST " )";" s# G. D2 d* l3 t8 d
OUTPUT $ "( 程式名称=" TP_NAME "本程式由" USER_NAME "编制 )";. s& |6 E! O( A( l
o: ~# X/ C+ H3 b
# W+ r. x. F( D; k# O+ |2 a. ^ 说明：1、*注释或代表不执行此内容；
7 w7 U7 a0 C- v/ g& V/ M4 v- ] 2、 引号里内容则按实输出；: E# N4 V" a0 N
3、修改保存完毕执行主菜单--NC--DFEXF--输入后处理名--回车即可。 |
|
发表于 2007-12-14 17:19:03