|
|
马上注册,结识高手,享用更多资源,轻松玩转三维网社区。
您需要 登录 才可以下载或查看,没有帐号?注册
x
是韩文的,哪位懂的话,能不能翻译出来,内容应该不错3 P; c% ~; r+ U( M* g2 Y5 J% Z7 H+ K0 r
! o1 a3 w" c. {! O5 B
Effects of Mn, Cr, and Sr Additions on the Microstructure and Tensile Properties of Al-7Si-0.4Mg-1Fe Casting Alloy& N" E/ k" E0 ^- i% ?, ]3 [: I
7 G$ Z/ I( X! o8 pJeong-Min Kim†, Joon-Sik Park, Ha-Young Kim, Jae-Ik Cho*, and Chang-Yeol Jung*
4 a h; c) [! T: ^& w+ ^3 k, V) oDivision of Advanced Materials Engineering, Hanbat National University, Daejeon 305-719, Korea
5 O& K8 s4 Z5 _$ J*Kwangju R&D Center, Korea Institute of Industrial Technology, Kwangju 500-480, Korea
. ?6 f" K& j$ Y: l
7 Q I4 P; M, c; b; R1 h5 N* W* cAbstract
! g+ a u: ~7 F: P5 c
* `8 U5 k, E5 ]" u f4 I/ ^The microstructure of Al-7Si-0.4Mg-1Fe alloy mainly consists of aluminum dendrites, Al-Si eutectics, and Al5FeSi needles.When Mn was added to the alloy, the substantial amount of Al5FeSi phase was changed into Al(Mn,Fe)Si, however the needle-like morphology was almost unchanged. Combined additions of Cr or Sr with Mn to the base alloy resulted in rod-like Al(Mn, Fe,Si)Si phase. The tensile properties of as-cast alloys were enhanced by the Mn addition, especially when it was added with Sr. The tensile properties after T6 heat treatment was a little improved with 0.7%Mn addition, but Cr or Sr additions with Mn didn't show any positive effect on the properties of heat-treated alloys.% H$ c8 U" {* p2 P+ J) f$ J4 i
0 C* }: T6 N- B
Key words : Casting, Aluminum alloy, Tensile Properties, Iron content.
# @7 n8 }% _( |' B- g3 K* J6 ~' W" A% N+ o6 B
/ a) U/ Q, q9 r5 j, V$ y; C5 Y P$ C
* J% b, D5 X& ~! ?
3 q! O4 S! ]! F5 j T1 ]6 x
[ 本帖最后由 三维观察员 于 2009-9-10 12:53 编辑 ] |
|