. Q- ]$ s. o# I! ]& q
按照romax简明建成建了这么一个模型，但是尺寸检查时出错4 F3 M) B; S0 b% r& N' I. M
Severity 6 K8 t5 M, ?3 K W" e: x# l
Message) s/ B) X" z) y; X
Action/Description 7 g8 B5 {9 P' ~# o
Failure
This integral cylindrical gear is mounted on a non-cylindrical shaft section' h/ i* Q2 V V& {
Change the shaft definition of shuchu at the mounting location of Wheel 6 to be cylindrical$ i2 D* k) s- Y6 x" [8 s
Failure
Integral gear Wheel 6 geometry is not compatible with the shaft section geometry it is mounted on. + o J6 h! F8 e$ w7 A9 J: T7 u
Check the section geometry of shuchu for sections7 |* i7 [1 M* q9 m& ]" n
- Shaft Section 28 g) b9 S; l$ r; H# w% ^( o9 C2 T
- Shaft Section 3 * e5 m) K! B% O( j/ B- Shaft Section 4 Z8 L2 \, ?: [0 f! x$ d
- Shaft Section 57 M* ^- P, E; {) S+ a7 q( R
The recommended limits are >=159.834 mm, <=172.014 mm1 C, e4 n/ A9 U. O/ H
The required limits are >=106.556 mm, <=258.021 mm, or make the gear blank a carrier type.: z" s: o% c5 u
3 s4 R \' o" `% e& L5 z请高手帮忙解答 $ n, B# B- [. m! E: Qexe1.rar(46.1 KB, 下载次数: 2)
发表于 2010-5-16 20:11:19
