简单模型在设置运动后仿真出现错误，无法找到初始位置：. h, I! N+ z! x
The Initial Conditions displacement solution failed. ADAMS/Solver could not determine the initial assembled position configuration of the model.+ ]1 |, B; }3 ]" N/ v
1)Try increasing the number of iterations for convergence. Current value: 25. ; D) q6 @6 d7 q, V" o" ~2)If redundant constraints are present try to eliminate as many as possible.$ C8 @5 A# b* E5 w! U! W
3)Make sure prescribed motions are consistent with other aspects of the current model position./ j( T& G& \0 X- e5 f2 d- T
4)Check to see if joints are inconsistent (contradictory); eliminate them if so.; F- ^# [& h3 ]7 F( A' j
5)Check to see if parts are not too distant from an assembled configuration.& ~+ }4 d4 K7 M8 V+ i
发表于 2007-11-26 22:44:37
;) ;) 新手不懂，请教。。。
楼主