SW2009怎么立刻出了这个Service Pack 1.0 Early Visibility

a1s1

这么快啊，就有sp1.0(EV)了。网页上看到的sp1.0说明
+ H# s8 ?! o0 D# [! Y, I- T6 z
6 c1 k  U$ e9 J* h! `Service Pack 1.0
Export to 3D XMLSave As 3D XML saves the file to the V4.2 specification of 3D XML.
Routing - Ribbon CablesYou can create folded ribbon cable routes. You can define ribbon cables from the cable/wire library, use the Auto Route PropertyManager to specify the path, and add ribbon cable connection points to connectors using the Connection Point PropertyManager.
3 L" d  g# ]5 ]$ r+ qFeaturesThe "Solid Sweep Cuts" section of the What's New book mentions the ability to create a solid sweep cut along a non-tangent path. This feature is not supported in this release.

Service Pack 1.0
) q2 j* I4 y0 Z8 I) S输出到 3D XML保存为 3D XML 会将文件保存到 3D XML 的 V4.2 规格。
Routing - 带状电缆您可以生成折叠的带状电缆线路。您可从电缆/电线库定义带状电缆，使用自动步路 PropertyManager 指派路径，然后使用连接点 PropertyManager 将带状电缆连接点添加到接头。
3 z2 K" o$ k8 W, \3 _
8 [! m0 P/ x. m[ 本帖最后由 a1s1 于 2008-10-30 19:44 编辑 ]

qxzch

早点出SP1吧，SP0还是有不少问题